Centrifugal Clutch 3/4 Bore 12 Tooth for 35 Chain, Common clutch for 2-6.5 HP engines 2300 RPM
Our go-kart clutch is made of high-grade steel, heavy-duty and long lasting. It can withstand the strain and heat caused by friction, once the clutch engages
Perfect for Go Kart, Minibike and Fun Kart. Fits Honda GX160, GX200, GX 140, GX120, GC160, GC190, Harbor Freight Greyhound 196cc, Harbor Freight Predator 212cc, briggs and Stratton Tecumseh engines and 2-6.5 HP with 3/4 shaft
Also fits any other engines with 3/4 crank shaft and 3/16 key way, most 5.5 HP clones, 6.5 HP clones and 4-7HP motors in all brands
Go cart clutch kit includes two set screws, but chain is not included
Our go-kart clutch is made of high-grade steel, heavy-duty and long-lasting. It can withstand the strain and heat caused by friction, once the clutch engages.
Go-kart clutches work best on these types of go-karts:
1. Racing Go-Kart
2. Homemade Go-Karts,Warm Tips:
About the Clutch Slipping:
Don’t try and reduce a go-kart speed by limiting the travel of the gas pedal or by putting a restrictor in the carburetor to limit full rpm. Either of these methods will result in the clutch slipping, which is self-destructive. A clutch needs full rpm to lock up as quickly as possible to be able to start to cool down. To slow down a go-kart you would need to purchase a gear reduction unit, which is like training wheels on a go-kart until the driver gets used to how the go-kart handles. A gear reduction unit can reduce the speed of the go-kart in half.
About the Clutch Smoke:
The clutch weight rpm just isn t excessive sufficient. The engine not being highly effective sufficient sometimes is the result of a mismatch in ratios to the rear-drive wheels. So the true motive is that the ratio just isn t steep sufficient, and subsequently, the engine smokes the clutch.
The treatment for the primary clutch smoking drawback is to change the driveline in order that the general ratio is steeper. The easy technique is to extend the rear sprocket diameter.
So the clutch engagement rpm must be taken under consideration in any other case the clutch will smoke on the secondary jackshaft mounting place.
